1. Check out the lot. No. so that installation can be applied with product of the same lot No. 2. Keep tiles the room temperature over 15˚C. 3. In case of installing below fifteen degrees, please use spacers as thick as a name card    on the interval between tiles. 4. Keep adhesives over 5˚C. 1. Making inking line from the center of floor.(If you    regard the center of the panel on the floor as a    start point, it is available to half-overlapped intall-    ation between double floor material and a tile 2. After applying adhesive overall and rolling floor,    please wait a moment until the color of adhesive    changed into the transparentness. 3. Install MAXI F&R TILE in accordance with    the inking line. 4. Do not install files too tightly so that they    do not come off the floor. 5. Install from the center to wall respectively, the     surroundings of column and wall should be     installed altogether. 1. Move heavy objects over protective mats after finishing installation. 2. Do not enter the site until inspection is finished. *What is 1/2 overlapped installation? 1. When lay-out or wiring is changed half-overlapped installation make it possible    to take 4 sheet of tile out in order to take a sheet of panel out. In case that panels and    tiles install in the same line, take 9 sheet of tile. 2. Make sure no water enters the bottoms of panels directly. 3. In case of defective installation of double floor, it is available to be covered.