Floor finishing is based
on leveling of manual
decoration on the surface
and done after clearing
dust or wastes. Existing
finishing of vinyl tile
can be executed by removing
the protrusion only.
Perform partition execution
in a way not to be separated
within 250mm from the
end of wall.
Draw the reference line
in 2m interval 125mm away
from Joint of Tile Carpet.
Connect joint block
along the reference line,
arrange floor mat and
then lay out on the whole.
Install slope and sill
as needed.
Use filling finishing
material(UMERU) for easy
manual work and generation
of less waste and loss.
In addition, cut FLOOR
MAT with circular saw,
reinforce it with supplementary
leg and lay it down.
Lay down carpet tile
continuously passing the
joint of FLOOR MAT.
Aluminum
Sill(H50,70,95)
Use it as a side finishing with
general floor.
Filling Finishing
Material (UMERU) (H50,70,95)
Use it around pillar or wall.
Aluminum slope
(H50,70,95)
Use it on the location for installing
slope such as passage of mobile
vehicles.
It is lightweight for H50, and
is available as resin product
for convenient execution.
SYSTEM
BOX
The height up to panel is over
H50
ISO 9001 Certificate
Exclusive
adhesive for TILE CARPET
ISO 9001 Certificate
STEEL Grating
(W250¡¿L500¡¿H45~95)
Use it as a vent under floor or
entrance of air layer around fan
coil.
Use exclusive bolt(separately
sold) to adjust the height of
floor.
ISO 9001 Certificate
£ª Remodeling(drilling, cut) part
of FLOOR MAT will have lower strength.
Reinforce the remodeling part with
supplementary leg among accessories.Make
sure to consult with our company
for remodeling.
£ª Falling of heavy object on the
floor or falling down from foot
stand may cause damage or deterioration
to floor mat.
£ª Moving of heavy objects or mobile
vehicle may cause a scratch on the
floor mat or have carpet pushed
away.
£ª If the installation area is small
such as wheel at the time of installing
heavy object, load may be give on
the floor mat, causing damage or
deterioration. In this regard, use
point mat separately sold on the
installation area.
£ª Do not remove panel except when
it is necessary.When continuously
removing floor without fixation
device, you may trip over it or
fall down..
£ª Regularly clean the room with
high humidity or which is not used
for long period of time for sufficient
ventilation. If it is not ventilated,
filter phenomenon may occur and
the joint area of tile carpet may
be polluted black. (Dew formation
on FLOOR MAT may cause an electric
leakage.)
£ª If aluminum sill or aluminum slop
is installed, you may trip it over
or fall down, resulting in injury.
£ªIf STEEL grating is installed,
never step on it. Be careful since
it may cause a damage or injury.
* Please understand that price
or specification may be changed
due to various circumstances.
* Please note that
color of product may be slightly
different from what you see in
the catalogue.
